Sans Digital iSCSI STORAGE Uživatelský manuál Strana 15

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 86
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 14
Complete all the hardware installation before booting the system. The connection to the controller port,
management port and iSCSI port should be completed rst
3.2 Management Methods
You can manage the Sans Digital iSCSI Series Products by one of the following three methods. Each
method is described as follows:
3.2.1 Web GUI (Graphic User Interface)
Sans Digital iSCSI Series Products support Graphic User Interface (GUI) for system management. Before
getting started, make sure the related network port is connected. If you want to use a static IP address,
make sure the IP address is not con icting with other IP address. You can use the “ping” command to
verify if IP address con iction occurs.
The default IP address of Sans Digital iSCSI Series Products is 192.168.0.1. The following instructions
describe how to start your initial setup by con guring a static IP address in Windows XP system.
Step 1 First, verify if IP address con iction occurs. Click StartRuninput ping xxx.xxx.xxx.xxx (the IP
address you are going to use). If you get a reply of “Request time out.”, then you can use the IP
address. It is recommended that you may also consult with your MIS personnel directly for the
related IP address information.
RAID Introduction 15
Zobrazit stránku 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 85 86

Komentáře k této Příručce

Žádné komentáře